The Bunny Egg
The Bunny Egg
Published 2018-04-13T10:11:47+00:00
This is my submission for the TinkerCAD Easter Design Challenge! I wanted to make a toy within an Easter egg and designed everything in TinkerCAD. The outside is an egg that splits in half to hold the bunny egg inside. The bunny egg is "collapsed" inside of the egg outside until you'd like to display it. You open the arms and feet and also put the head on top to finish assembly. I tried to make it the same size as a regular egg but it would work even better as a larger object. This is one of my first "large" designs with TinkerCAD and I had a really fun time making it!
This object was made in Tinkercad. https://www.tinkercad.com/things/9rBjIi0GMmG
Print the arms upside down so the support material is easier to remove. Also print with layer height as small as possible to get the most accurate prints. Print larger to have an easier time with cleanup and assembly. I used orange PLA at 10% infill, 205C print head, and 55C bed temp. I have a cheap printer so I would guess it would print even better on a newer one.
Date published | 13/04/2018 |
Benoetigte Zeit | 180 - 360 Minuten |
Menge an Filament | Depends on print settings |
Dimensionen | 40mm X 40mm x 52 mm |
Technologie | FDM |
Schwierigkeitsgrad | Easy |