The Sorceress: Spellcaster!
The Sorceress: Spellcaster!
3D
Published 2019-11-26T21:25:11+00:00
This is a "sequel" to my original Sorceress model. In this sculpt I wanted to make her far more dynamic - in this pose she is about to cast a most powerful spell (or at least that's the way I see it).
I started this sculpt ages ago and then dropped it because well - it happens. Upon revisiting her, I changed her hair so she will print on my resin printers without supports. She will work well for FDM too but you may need something to support her chin.
She is a free model to say thank to all those people who purchase my commercial work.
There is also a "saucy" version of this Sorceress available in the "naughties" section on Cults:
https://cults3d.com/en/3d-model/naughties/the-saucy-sorceress
Designed to be printed on a resin printer. Has been tested on the Prusa SL1 and the Elegoo Mars.
For convenience, I am including the following files:
1) The model as a solid. This is suitable for FDM printing and for resin printing, people can make their own decisions regarding hollowing and/or drain hole locations. For FDM printing you may need supports for her chin. I did not find this necessary for resin printing.
2) The hollow shape and drain holes as subtractive shapes that I used. These can be used as a point of reference or just some ideas. You would need to subtract these from the solid.
3) The model pre-hollowed with my shape and drain holes. This is suggested only with the model at the current scale and printed with the base flat on the bed and was successful with the Prusa SL1 and the Elegoo Mars. I do not guarantee success with other printer models and scales and you use these at your own risk.
| Date published | 26/11/2019 |
| Dimensionen | 68.91mm x 40.03mm x 146.69mm |
| Support Free | YES |
i am new to resin printing. Printed on Creality LD-002R resin printer using water washable resin. 1st time success from a perfect file no supports. Thank you Louise!!!