Arm guards for the EMAX Tinyhawk Freestyle! The freestyle is tough but I ripped the arms up a bit sliding on concrete so I thought these were a good idea.
This part acts as protection of the carbon frame and soft landing gear as well as soft mounts for the motors
You will need to print 2 mirrored ones as well as 2 normal ones to fit the whole quad, any major slicer has model mirroring capabilities to do this.
Unscrew the motors and slide the print on from the end of each arm with the flat part of the print facing up and screw the motors back down, be careful with the motor wires as they are fragile!