Tricky Turning Connecters
Tricky Turning Connecters
Published 2015-10-22T12:04:59+00:00
Try these Tricky Twisting Turning connecters!
Fit them into your Tricky Bricks to bridge and stack them in new ways! Watch out though, these connecters can twist so experiment with other bricks and weights and see if your connecters can bare the load or twist and topple!
Download the starter collection here: https://www.myminifactory.com/object/tricky-bricks-14024
The components are simple, once printed use your pin piece to connect two of the arrow pieces together. Once you have removed any raft ect you'll notice that the tollerance allows you to push components together with ease and then to twist and turn the two arrow blocks freely. I recommend printing the a variety of the following combinations so you never have to detach from the pin piece:
Arrow piece 180° + Arrow piece 180° + Pin piece
Arrow piece 180° + Arrow piece 90° + Pin piece
Arrow piece 90° + Arrow piece 90° + Pin piece
And then just keep building and adding to your collection - printing a new Tricky Turning Connecter when you just want more!
Check back to Lucia's MyMiniFactory profile over the next few weeks for tricky brick add-on packs, and adaptations of the game, which will be available to dowload and 3D print for free directly from MyMiniFactory
Have fun! - but remember - don't knock 'em till you try 'em!!
Check to see that your orientation is correct using the demonstration picture. These connects were printed with an in-fill density of 10% to keep them light weight and quick to print. Its advised that increasing the in-fill density especially for the pin piece will make these connectors more durable Layer height: 1mm Objects are support free
Date published | 22/10/2015 |
Benoetigte Zeit | 120 - 180 Minuten |
Dimensionen | 25x50x25 |
Schwierigkeitsgrad | Very Easy |
Support Free | YES |