UNIVERSAL MOBILE STAND
UNIVERSAL MOBILE STAND
3D
Published 2015-07-07T17:39:07+00:00
This universal mobile stand aims to fit most phones on the market. The first problem of a charging stand when they are 3D printed is the weight of the stand. They are too ligth. So I decided to weight the base with coins (fits american and canadians quarters). I advice you to put 8 coins, 4 on each side. They are pockets where you can drop them. Then there is the problem of the different sizes of the charging cable. I created a pocket where you can drop the charging end of the cable and secure it with coins (See picture). Maybe you will need three coins, maybe just two. This is experimental. I don't own a 3D printer so I can't check that it actualy works. So feel free to get in touch and if you want me to tweak the design I will do it.
Print at 0.2 mm layer height, with 10% infill. This uses 69 g of filament and takes 6 hours 36 minutes.
| Date published | 07/07/2015 |
| Menge an Filament | 69g |
| Dimensionen | 84x100x100 mm |
| Schwierigkeitsgrad | Medium |
