The green & autumn version: leaves printed at 100% scale, trunk 110%. Making the trunk bigger made it possible to put the leaves in easily. Trunk took approx. 5 hours to print at 0.1mm and 15% infill, and the leaves took approximately 1hr at 0.1mm and 100% infill (printed 2 at the time). No raft and support. Designers print (green and white): Both STLs can be printed directly to the print bed with out support structure or a raft, I had that feature switched off on mine, the raft makes such a mess to remove. The leaf STL is optimised for a layer thickness of 0.15mm, any larger and you'll start to lose detail. Also the "number of shells" was set to zero. Otherwise you lose detail again. I don't know if the MakerBot slicing software has that as a configurable feature. I tried to generate the code for my FlashForge a while back using MakerWare, but it tried to make the print head move off its rails! It didn't sound good either. For my test prints I used 1.75mm PLA with a nozzle temp of 205 deg and a print bed temp of 50 deg. Printing in White and Jade Green transparent.