Wanhao D7 no screws vat, windowed and mark levels version
Wanhao D7 no screws vat, windowed and mark levels version
3D
Published 2017-08-30T17:05:44+00:00
Based on my wanhao D7 version without screws, this version incorporates a window where you can attach a glass or an acrylic (between 2 and 3mm) to allow you to see the print during the process.
Using transparent double-sided tape and FEP will not muddy the vision too much and allow you to see if the print is working.
I leave the link of the version where you can see how the FEP is installed, that version has been used and tested: https://www.myminifactory.com/es/object/wanhao-d7-no-screws-vat-42564
This new design HAS NOT BEEN TESTED, basically it is the same design that the previous one that has been added a window and interior level marks and some aesthetic improvements, being based on my previous design I think that if an acrylic or glass is installed in the window and no leaks everything should work like the previous one.
PLA, use suports, 99% infill
| Date published | 30/08/2017 |
| Technologie | FDM |
| Schwierigkeitsgrad | Easy |