Wide Business Card Clip Holder
Wide Business Card Clip Holder
Published 2015-03-31T16:54:05+00:00
This is a one-piece business card holder that clips your cards so they don't fall all over the place. It will hold up to about a 7mm thick stack of cards, 3.5" wide.
Print vertically; there are supports baked-in to the model, optimized for 0.5mm extrusion width and 0.25 mm layer height. There are some big support panels that will pull off by hand, and four tiny support webs that need to be trimmed off of the front clip bars with a hobby knife. It will print well with zero infill and a 1mm thick shell, for the best appeareance with clear or translucent filament. (clear ABS is shown in the photos) With these settings it printed in 4 hours and 40 minutes, using 28g of filament.
Date published | 31/03/2015 |
Benoetigte Zeit | 184 - 194 Minuten |
Menge an Filament | 37 g |
Dimensionen | 100 x 49 x 50 |
Schwierigkeitsgrad | Medium |