Wonder Woman's Sword
Wonder Woman's Sword
3D
Published 2017-03-20T12:08:06+00:00
This is Wonder Woman's Sword from the upcoming movie "Wonder" due to debute on June 2nd 2017. This sword is based off of stills taken from the movie's trailers. I could not model the details of the dragons that hold the blade, due to a lack of software, however the general shape is there. What do you think?
I used E6000 glue, sand paper, masking tape, spray paints, a respirator, and patience to complete this full sized model.
I hope to also complete Wonder Woman's headband, and her wrist cuffs soon too. Until then, hope everyone enjoys.
3mm layer height.
20% infill.
3 top, 3 bottom, and 2 perimeters.
Supports on, and if possible use 1mm support resolution.
The square pegs and holes have a 0.3mm tolerance, and if you can, remove supports from the square holes located on the bottom of the model's pieces.
The purpose of these pegs is to help with alignment when assembling, but dont play around with them too much before gluing as they may break off.
| Date published | 20/03/2017 |
| Benoetigte Zeit | - 780 Minuten |
| Menge an Filament | 264 grams |
| Dimensionen | Unassembled Tray 80mm x 120mm x 200mm |
| Technologie | FDM |
| Schwierigkeitsgrad | Medium |
