Zombie Card Box & 3 Lids
Zombie Card Box & 3 Lids
3D
Published 2020-03-21T18:45:13+00:00
Expanded capacity card box, with Zombicide(black plague) logo lid, Zombicide(Invader) or Blank lid which is included with the files.
EDIT: I added Base V2, Zombicide- Black Plague & Invader V2. the only difference in V2 files is I added 0.5 more depth on the lid in-case you need to use a drill bit on any of the magnet holes there is a bit of wiggle room without drilling through.
I have used the Zombicide Card box that has been in heavy circulation on Thingiverse for many years but found that it was not hitting all of my needs. Box I used Much love to the creator!
Rather than try to re-mix I decided to fire up Illustrator and Fusion360 and start from scratch to meet all my needs.
More Capacity- check
Very stable lid-check
More magnets-check
Thumb width gap on each side-check
Contoured edges, bonus-check
Printing notes
This uses 20 magnets 3mm x 3mm
I printed this in PLA at 0.16 layer height, a 14 line brim to make sure that the edges would not curl. The holes for the magnets, it did require me to use a 3mm drill bit to true up the size as they printed a fraction smaller ( I think it was due to my horizontal expansion settings) but it did not take much work.
I hope this can serve the need for others as well.
If you print this and have any suggestions please let me know. This is my 3rd actually printed design in Fusion360 and I am still learning.
Cheers!
| Date published | 21/03/2020 |
| Support Free | YES |
thanks