THIS MODEL IS COVERED BY MMF COPYRIGHT, SO YOU CANNOT SELL IT OR UPLOAD IN OTHER WEBSITE WITHOUT MY PERMISSION
I look around and i find someone try to replicate the Penny Board but without success, so i decide to take this challenge and i won!
I suggest to print the pin in 100% and all the other piece with an infill from 25% to 100%.
The back part i suggest to print from 75% to 100% need to be really strong!
You need 3 steel bar with 6.4mm diameter:
- 2 long 43 cm
- 1 long 45 cm
HERE THE VIDEO!