Union|Nine's Print of Elder Wand
Featured
2,015
views
1 comments
Loading comments... 
Community Print 3D Print of Elder Wand
Published 2016-08-03T12:42:18+00:00
6
1
Printed on: ZEUS All-In-One 3D Printer
Material: PLA
Description
I had to re-work the file a bit to get it to fit my printer, and also to adjust scale/proportions to make it a bit more sturdy as it was over the fandom-quoted 15" in length and quite skinny. So, it ended up being 3 pieces instead of 2, and I also cut a cylindrical center hole to run a pinning piece of material through all three pieces to help hold it together.
Then a few undercoats of spray-paint with some acrylic brush-work on top, and this is the end result!