KenPuckett's Print of Gear Keychain/Pendant
Community Print 3D Print of Gear Keychain/Pendant
Published 2018-01-06T02:05:29+00:00
0
0
Description
Not bad. I should have printed it way bigger. The caps unfortunately came out as nothing but two little dots of filament so instead I took a lighter to the tops of each spindle for a second and then flattened them on a table. Seems to be holding the gears in pretty good. I also had to drill out the holes in the gears a little wider, plus I added a few drops of oil for better movement. (I didn't bother sanding the spindles.)