Z-REX
Z-REX
3D
Published 2017-03-21T11:57:31+00:00
Z-REX's (pronounced "Zee - Rex") are small, easy and fun prints of a dinosaur model... with an opening mouth / jaws and teeth that bite.
No support required... just print it with at least 3 shells and 50% or more infill to make the jaws / mouth springy so they open and close.
At standard scale Z-REX's are 125mm long. You can safely uniformly scale them up (as this will increase internal clearances), but scaling them down may result in the mouth / jaws not moving.
Please refer to the images provided and print instructions for additional information... and post photos of your Z-REX's.
Z-REX's work in the same way as my SHARKZ / CROCZ / EAGLEZ etc. These prints can be found at:
'Snails' https://www.myminifactory.com/object/30353
'Fish Fossilz' https://www.myminifactory.com/object/30368
'Bugz' https://www.myminifactory.com/object/30415
'Sharkz' https://www.myminifactory.com/object/30262
'Snakez' https://www.myminifactory.com/object/30413
'Ratz' https://www.myminifactory.com/object/30361
'Crocz' https://www.myminifactory.com/object/30274
'Woodpeckerz' https://www.myminifactory.com/object/30348
'Eaglez' https://www.myminifactory.com/object/30290
'Catz' https://www.myminifactory.com/object/30296
'Scorpionz' https://www.myminifactory.com/object/30301
'Piranhaz' https://www.myminifactory.com/object/30424
Note: If you like this check out the rest of my fun and practical designs.
This is an easy print and works great in PLA... not tested in ABS.
Do not use 'any' automated support otherwise your Z-Rex jaws / mouth may not move. Print with at least 3 shells and 50% or more infill to make the jaws / mouth as springy as possible.
Train your Z-REX not to bite things it shoudn't!
Tell us more...
| Date published | 21/03/2017 |
| Tecnología | FDM |
