A belt holster for the Eleaf Power 80W box mod
3,316
visitas
54
descargas
0 comentarios
Cargando comentarios...
A belt holster for the Eleaf Power 80W box mod
3D
Published 2017-01-16T10:39:31+00:00
2
0
Add to Collection
Descripción
A simple belt holster design, for the Eleaf Power 80W box mod. Printed in PLA, with a 25% infill.
I printed mine on one side, so the layers ran vertically through the case, making it as stong as it can be, where it will be in tension.
I needed to turn on support for the finger slot in the front, since it was laying on it's side, and there is some bridging on the inside of the case.
The hole in the back, for a belt to go through is pretty wide, because I wear a fairly thick belt, so it should work well with all kinds of belts.
Would love to see some photos, if anyone prints or even remixes this!
Información técnica
Date published | 16/01/2017 |
¿Cuándo tiempo lleva? | 300 - 360 minutos |
Cantidad de filamento | 58 grams |
Dimensiones | 58.5mm 48mm 84mm |
Tecnología | FDM |
Más información
Archivos