Second and final carabine kit for mk23.
If you like my design, you can sgive some tip.
Longest piece is 270mm.
Please print for others but do not make money from that design.
need M4 screws and nuts for assemble, also 1 m3 on top.
Pistol will fit very snug, therefore, please print 100,3%
Probably need some fine sanding on pixatinny, to fit grip etc.
those measur are approx. because i cutted them as they were too long:
Front m4x45 (2 screws)
Andsome m3x12 to secure rail part
I grinded them afterward.so you should do same.
Supports need on body screw holes and for picatinny rail on lower module.
I printed from ASA, but should wok fine with PLA etc.
Please print with no less than 3 perimeter shell, dont want it break like other
printed kits, what ppl selling.