Airsoft Shooting Swinging Target
Airsoft Shooting Swinging Target
3D
Published 2018-06-01T13:58:06+00:00
My son wanted a swinging target to shoot with his airsoft and BB Gun. I created this target stand and swinging targets.
It has room for 3 Targets, 2 big 1 small.
I've modified the design from the first version to include the following:
• Cross bar has groove on the bottom to insert into side supportsfor added stability
◦ thicker target hangers (1 snapped when removing it from bed)
◦ Blocks on bottom of Side supports to reduce Horizontal movement
Instructions
1) Print the Parts
Print out two of the "supports". I added a block on the bottom of each to prevent horizontal movement of the stand.
Print out the "Cross Bar" with supports as you will need it because of the rounded sections.
Print out a set of the targets. You will also need to print it with supports.
2) Snap together the parts
Remove the support material from the targets
Snap the targets onto the cross bar
Insert the cross bar into the square holes on the supports
align the groove on the bottom of the cross bar with the supports and press down to lock in place.
| Date published | 01/06/2018 |