Ball Fidget Spinner
2,994
visitas
62
descargas
0 comentarios
Cargando comentarios...
Ball Fidget Spinner
3D
Published 2017-07-07T15:48:16+00:00
4
0
Add to Collection
Descripción
This spinner uses a standard 608 skateboard bearing in the middle hole, and 14mm steel ball bearings as weights. The ball bearings can be pressed in by hand.
Print two of the caps to place inside the center - if you find they're too tight scale them down a few percent and print again, and if they're too loose just glue them.
You can also make custom caps here :
https://www.thingiverse.com/thing:2083000
I found the large 3-ball spinner was too big for kids' hands, so I've included a smaller 2-ball version for kids.
Información técnica
Date published | 07/07/2017 |
Tecnología | FDM |
Más información
Archivos