Here are some big LEGO-Style flower heads for you - with a bouquet stem and a single stud.
They are 10x bigger than LEGO bricks and they are compatible with my first playable LEGO-like flower:
Big Flower LEGO style
What I love about LEGO is that you can combine each brick with all of the other bricks and create amazing things.
That's what I wanted my big flower to be!
So I started from scratch, doing lots of measuring, testing and printing.
The result is a flower, which is 10x bigger than the original LEGO flower - and it behaves like it, too!
The blossom has a round, hollow stud, that fits under the stem or under big bricks.
It's hollow underneath to fit on top of each other or studs from 10x bigger bricks and in between of four of them.
The stem is stackable, too. It fits inside the top of the flower plates and on top of each other.
And the single round plate fits on top and unterneath the flower plate, other round plates or studs.
This means, you could upsize each brick suitable for LEGO here on thingiverse and combine it with these files.
And you can even downscale them and it still works!
Print the parts at 20% scale and they will fit on DUPLO bricks.
I printed most of them at 50% and they fit perfectly on my 5x LEGO bricks.
Have fun with my version of this flower, print some big bricks and create your own giant brick world!
Please share, if you made one!
Tested with PLA and PETG.
Both works, but PETG is better, if you want to play with them.
If you have a chunky Z-seam you should sand it or cut it down.
It might cause the parts not to fit propperly and/or makes it harder to seperate them.
If you don't get the flower on the stem, sand the hole inside the flower plate just a little bit. It's supposed to be a (very) tight fit, the more you use it, the easier you get it on and off.
If the parts are stuck together, simultaneously pull and screw them (don't bend) - this will loosen them and they will fit better the next time.