Blue Yeti cable protection
Blue Yeti cable protection
3D
Published 2018-07-10T11:12:22+00:00
I had problems with my old Yeti glitching, the fault seemed to be the connector being "worn out".
The shop I bought it from said this is quite a common problem with this model...
To make sure this doesn't happen to my new Yeti I've made this cable holder/wiggle protector.
It should keep the connector from moving around in the socket, causing a bad fit over time.
For me it was a slight friction-fit so no need for fasteners.
You can check out the other projects here:
http://www.youtube.com/c/MrCrankyfaceProjects.
Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface
| Date published | 10/07/2018 |
