Cable Management Tray
Cable Management Tray
3D
Published 2018-07-14T18:12:35+00:00
Hi Everyone,
I was so tired of seeing my charging cables laying all over the floor so I wanted to design a little simple cable management holder. I used 3M Command mounting strips to secure the holder to the back of my dresser. Now I just grab the cable I need, charge my device and put the cable back into its holder. My wife liked mine so I printed one for her as well. Hope you like it.
Printer: Creality, CR-10
My basic profile settings I used in Cura
Layer Height: .2
Walls: 2
Top/Bottom Layers: 3
Infill: 10%
Supports: No
Inland Filament: Nozzle - 210, Bed - 60
I printed this with no raft, It's up to you if you feel you might need to use one. This does not require any supports. Total time to print was about 1 hour and 20 minutes depending on your settings.
| Date published | 14/07/2018 |
| ¿Cuándo tiempo lleva? | 80 - minutos |
| Cantidad de filamento | 20g |
| Dimensiones | 101.6 x 27.4 x 35.0 mm |
| Sin apoyo | YES |
