Ceiling Solder Fume Extractor Fan Adaptor 250mm Clipsal AirFlow CE250
Ceiling Solder Fume Extractor Fan Adaptor 250mm Clipsal AirFlow CE250
3D
Published 2020-05-29T16:38:17+00:00
Adapter to connect a removable 150mm flexible duck to a 250mm Ceiling Extractor to remove Solder / Flux fume.
designed to be printed on a CR-10S PRO , so a 300X300 bed size
because of the size of the BaseCoverRetainer , i had to break it into 2 to fit on the bed, then glue those to the Base directly.
also design WallRetainer to hold the Base directly, since i was not sure if the superglue would be strong enough. Can't be too careful...
using 4 X Wall Retainer, but you can also not use them, or use more of them...
wing 4G 9mm Sheet Metal screws to the airflow plastic Grille
Ceiling can is a Clipsal AirFlow CE250
https://www.clipsal.com/products/detail?CatNo=CE250
initially designed to have a 5 - 6 mm Rubber EPDM Sponge to improve the seal, but the seal was very good as is, so i did not put any rubber seal between the base and 150mm adapter. using the Hook-1.5mm
make sure the Hook are laid flat on the bed to increase strength.
Hook are using M3 X 10mm screws. Base already have pre threaded M3 holes
150mm flexible PCV Duct used
https://www.bunnings.com.au/blauberg-150mm-x-5m-pvc-duct_p4420308
##### anti draft / Backdraft stopper adapter for it it live (31/05/2020)
https://www.myminifactory.com/object/3d-print-123590
will also design a 150mm to 75mm adapter for the flexible smoke exhaust pipe when i get it
https://www.aliexpress.com/item/4000044513445.html
##### Flexible Fume Exhaust Bamboo Pipe OD75 ID68 Bracket and 150mm Duct Adapter is live (20/08/2020)
https://www.myminifactory.com/object/3d-print-131497
FreeCAD design files included,
Fastener workbench required.
| Date published | 29/05/2020 |