Christmas Tree Stand Knob
1,756
visitas
50
descargas
0 comentarios
Cargando comentarios...
Christmas Tree Stand Knob
3D
Published 2019-01-14T10:30:11+00:00
2
0
Add to Collection
Descripción
My christmas tree stand has four 5/16" (8mm?) threaded rods that you use to adjust the christmas tree in the stand. The back of the rod is free of threads and is bent at a 90 degree angle with about a 1" tail, sort of like an allen wrench. The stand came with little red plastic covers that would go over the end of the rod and make a sort of T so you could tighten them by hand to straighten the tree. Well, of course over the years I lost some of them. And it is really hard to get the stand tight on the tree without them. So I made this X-handle version to replace it.
Detalles de impresión
You can scale up or scale down to fit the knob for your tree
Información técnica
Date published | 14/01/2019 |
Más información
Archivos