Clapton Coil Maker
Clapton Coil Maker
3D
Published 2018-05-03T12:10:49+00:00
Based off the Daedalus Coil Maker. I didn't want to spend $70+ on one because it comes with a drill...
Print it, assemble it, grab your wires and your drill and make your own coils! I made this off of pictures and videos.
Let me know what you think. I'll post videos soon
Print Maker Base UPSIDE DOWN WITH SUPPORTS TOUCHING BUILD PLATE (for the insert of the jig). I did 15% infill...
Print Jig with SINGLE HOLE TOUCHING BUILD PLATE and 3 HOLES UP for a clean print... I did 15% infill...
Print Bolt 70mm ON SIDE WITH FLAT SIDE DOWN FOR THREAD STRENGTH and USE SUPPORTS. I did 20% infill...
Print Spring UPRIGHT WITH SUPPORTS and 100% INFILL FOR A FIRM SPRING.
Print 2 Springs Caps. I did 15% infill...
Print 2 25mm Washers. I did 15% infill...
The Steel Spring Caps are for the spring out of a MAG-LITE Flash Light. The one I used is out of a C battery mag lite... I did 15% infill...
| Date published | 03/05/2018 |
| Tecnología | FDM |
| Complejidad | Fácil |