Classic Wooden Top
Classic Wooden Top
Published 2018-07-20T16:42:55+00:00
Fun toy top designed into three peices to print without supports.
Well balenced; if you give it a good spin it'll last >1 minute.
I have since designed a multi-color version of this design (linked below).
Multi-Color Tops:
https://www.myminifactory.com/object/3d-print-143207
Products used:
https://filaments.ca/?rfsn=4740568.a03b49
Note: Affiliate link above - I earn a commission from qualifying purchases at no additional charge to you just by using the links listed which helps support the channel.
To find more of my work, please check out my website: http://wrightbuilt.ca/
To download any of my own 3D designs, check out my design library: https://www.myminifactory.com/users/WrightBuilt.ca
Support me by Subscribing/Liking my YouTube channel, or by tipping me via MyMiniFactory (PayPal) here: https://www.myminifactory.com/users/WrightBuilt.ca
You can find my disclaimer here: http://wrightbuilt.ca/disclaimer-page/
Printed with a wood filled PLA ath 150um. I printed 2 at the same time in 3 hours.
Orient the print so that the flat surface of each part is on the print bed.
Date published | 20/07/2018 |
¿Cuándo tiempo lleva? | 2 - minutos |
Tecnología | FDM |
Sin apoyo | YES |