Clickaloo Shark
Clickaloo Shark
3D
Published 2018-09-04T12:07:57+00:00
Clickaloo toy!
Always been fascinated by sharks. I collect shark teeth (seen in the picture), my favorite being megalodons! I designed this shark to swim like one. This can also be transformed into a dolphin (just need to print a few more parts and rotate it). Will release plans soon.
Dolphins swim with tail primarily going up and down while sharks go left to right.
The assembly requires:
- 10x 1SBP-FT
- 6x 2SFP-FT (if you want the shark to move)
- 24x 2SCP-FT (30 if you dont want the shark to move)
- 11x 3SCP-FT
- 3x 1HSP
- 7x 3HSP
- 2X 4HSP
- 2X 5HSP
- 1X 90DFA-I
- 2X 45SFA-O
- 11X 90SFA-O
- 11X 90SFA-I
- 2X 16HLA
- 2X 12HMA
- 1X 8HSA
- 1X 7HLA
- 1X 5HMA
- 2X 3HMA
- 2X 4HMA
Pictures and instructions attached for assembly. Please visit : http://www.clickaloo.com/parts/
to get the mentioned pieces above.
Printed all pins with ABS-ECO on the Dremel 3D45.
If you use PLA for the clips, you will need to print them on their side to increase durabililty. Otherwise they will snap almost instantly.
Printed all other parts with PLA on the CR-10S.
I would recommend doing all parts in ABS. Several of my L shaped brackets broke during assembly.
| Date published | 04/09/2018 |
| ¿Cuándo tiempo lleva? | 2 - minutos |
| Tecnología | FDM |
| Complejidad | Fácil |
| Sin apoyo | YES |
