Clip-on print head holder
2,730
visitas
103
descargas
1
colección
0 comentarios
Cargando comentarios...
Clip-on print head holder
3D
Published 2016-09-26T15:03:11+00:00
4
0
Add to Collection
Descripción
This is a clip-on for my Micromake D1 Delta printer. Should fit similar printers with the V slot rails. Happy to hear any comments. Tip if you feel like it.
Printer: Micromake D1
Rafts: Yes
Supports: Yes
Resolution: 0.3mm
Infill: 20%
Notes:
Best to print it vertical, to give the clip maximum strength. It was a trade-off between a bigger clip (long print time) and this.
How I Designed This
Used 123D Design, measured the rails and extruded from an initial sketch.
Información técnica
Date published | 26/09/2016 |
Tecnología | FDM |
Más información
Archivos