Compact Raspberry Pi Rack
13,393
visitas
512
descargas
11
colecciones
2 comentarios
Cargando comentarios...
Compact Raspberry Pi Rack
3D
Published 2019-03-07T11:14:29+00:00
150
2
Add to Collection
Descripción
This is a compact Raspberry Pi horizontal rack.
The boards are all placed vertically instead of the traditional horizontal layout.
It consist of a single base a some small supports for the boards you decide to attach.
Advantages of this design:
- Better heat management: the heat goes up and doesn't interfere with the board above because there isn't any.
- No need for fans: heat can freely escape vertically.
- Very compact design: this 5 slot stack has a length of just 14 centimeters.
- Board support: it supports a wide variety of boards and disks.
It supports almost all the available boards:
- B+
- 2B
- 3B
- 3B+
- Zero
- Zero W
It also supports 2.5" Hard Disks or SDD's.
There is enough space below for WIFI dongles (see the picture).
At the moment it has space for 5 slots but it can be easily edited to support more or fewers slots (if you need more than 5, please leave a comment asking for it).
Requirements:
- It only accepts Right Angle (90º) USB power connectors.
- Some 2.5mm screws for the supports.
Detalles de impresión
No supports needed.
Mine was printed at 0.20mm with Gray PLA.
Took about 3 hours to print.
Información técnica
Date published | 07/03/2019 |
¿Cuándo tiempo lleva? | - 1 minutos |
Dimensiones | 140mm x 92mm |
Tecnología | FDM |
Sin apoyo | YES |
Más información
Archivos