COVID Mask Cookie Cutter
COVID Mask Cookie Cutter
3D
Published 2020-11-24T09:32:01+00:00
Make COVID-Mask-Cookies for the worst Christmas ever - 2020 hooray!
Check my profile for other Corona-related Cookie Cutters :)
There are three parts:
1. The actual cutter for the mask-outline
2. A stamp for adding the details
3. A handle for the stamp
The cookie tends to distort when trying to move the cut cookie onto the baking plate so its best to roll out the dough on a baking sheet already on the plate, cut and stamp it and just remove the excess dough.
Instructions: Dip both parts in flour to make them less sticky. Insert the handle into the slot in the back of the stamp and twist it to lock it in place. Cut the cookie, then stamp it with the outline cutter still in place. Don't stamp it too deep. Remove the stamp and carefully lift the cutter.
PLA works just fine
printed in 0.3mm layer height with 3 solid top/bottom-layers
Dont put PLA prints in the dishwasher!
| Date published | 24/11/2020 |
| Sin apoyo | YES |