Daisy - Flat flower
14,379
visitas
1,929
descargas
21
colecciones
3 comentarios
Cargando comentarios...
Daisy - Flat flower
3D
Published 2017-03-20T11:37:16+00:00
236
3
Add to Collection
Descripción
I had some success with the production of leaves using this method and wanted to see if it could be applied to flowers. Assemble all parts. Then, heat the petals and bend them. I've also found this is a good way to burn your fingers, so be careful.
"Flower Petal 1.stl" and "Flower Petal 2.stl" are not the same. One of each will need to be printed.
"Flower Stem.stl" will need to be printed twice.
You may need to add a Brim to the stem.
Información técnica
Date published | 20/03/2017 |
¿Cuándo tiempo lleva? | - 360 minutos |
Dimensiones | 300, 100, 100 |
Tecnología | FDM |
Complejidad | Difícil |
Más información
Archivos
I decided to skip the leaves and had to make a tweak to the top of the flower (the original STL did not have a hole in the flower petal center file (used meshmixer to create a hole that would fit the stem) so it is all just friction fitted. No glue needed. I then just scaled the stem to be as long as I needed and the results are as you see. Awesome work, thank you so much! Gave them as a mothers day gift.