DIY 3D Printable Camera Ring Light
DIY 3D Printable Camera Ring Light
3D
Published 2020-05-22T11:34:49+00:00
When it comes to video creation and Instagram photos, lighting is one of the most important reasons for great captures. I needed a custom ring light for my videos and Instagram photos; the light had to be cheap, easy to make and use the electronics I had access too. I designed, 3D printed and assembled the entire lighting system.
The light has become our daily light setup when capturing photos and videos.
The models are printed in PETG Plastic with a 20 % infill (some areas have a 0% infill but increased shells) and printed with 0.28 mm layer height. PETG was used due to the heat generated by the LEDs.
Complete Part List:
Tools:
A 3D Printer
Screw Driver
Flat Nose Pliers
Craft Knife
Materials:
PETG Material
1 x M5 Bolt
2 x M5 Washers
1 X M5 Nut
3 x M3 Bolts
3 X M3 Nuts
1 x White LED Strip Light (Approximately 1-metre length)
1 x LED Power Adapter/Source
1 X Female Jack
1 X Heat Shrink (Cut to size)
1 X Quick Dry Glue
Watch the Youtube Video see how I made this.
Material: PETG
Layer height: 0.28 mm (Fast printing - quality low)
Wall Thickness: 1.6 mm
Shells: 4
Nozzle diameter: 0.4 mm
No Supports needed
| Date published | 22/05/2020 |
| ¿Cuándo tiempo lleva? | 804 - minutos |
| Cantidad de filamento | 101 |
| Sin apoyo | YES |