Dovetail to Dovetail Riser - 2.4cm Elevation
$3.00 Dovetail to Dovetail Riser - 2.4cm Elevation
Published 2020-11-10T11:41:38+00:00
A riser I made for dovetail rails. Elevates an optic (or whatever else you might want to stick on there) by 2.4cm. Good for pellet/air guns and anything else that uses the standard, where you need a bit more clearance for your optics.
Dimensions:
Optics Clearance: 2.4cm
Overall Height: 2.6cm
Top Rail Length: 7.1cm
Bottom Mount Length: 7cm
Top Rail Over Bottom Rail Shift: 1cm
Overall Length: 7.9cm
Width: 2cm
To print, leave as oriented in the file. Set supports to touch buildplate only. You can get away with 20% infill PLA prints for light duty use, but for the best durability results, print in ABS at 100% infill
To print, leave as oriented in the file. Set supports to touch buildplate only. You can get away with 20% infill PLA prints for light duty use, but for the best durability results, print in ABS at 100% infill
Date published | 10/11/2020 |
Precio | $3.00 |
Dimensiones | 2.6cm x 2cm x 7.9cm |