"Droplet" Bird House
"Droplet" Bird House
3D
Published 2019-07-03T18:40:15+00:00
This hanging birdhouse was designed around not needing any support material. A seed pan extends 3cm out from the bird house, and is 360° around it. The feeding pan has 2mm drainage holes around the bottom, should heavy rain occur, and will help avoid flooding.
This should be printed in PETG, but since I ran out for this project, a bright colored PLA should reflect plenty of light away to help avoid overheating and melting on hot summer days (Though it's still advised to just use PETG) As such if using PLA, try hanging it in a decently shady area.
Standard Print Settings:
Extruder: 208C
Bed: 62C
First Layer Print Height: .30mm
Wall Thickness: .80
Brim Width: 5mm
Wall Perimeters: 2
| Date published | 03/07/2019 |
| Sin apoyo | YES |
