earrings holder
earrings holder
3D
Published 2017-08-30T14:32:21+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
A flower to hold earrings, with a cone for rings. Great for bedside table.
Full size is 162.5 x 163 x 74.4 mm, and takes about 15 hours to print. (See screen images for Cura setup.)
At 60%, holes are 2mm diameter and bounding box is 97.5 x 97.8 x 44.6 mm, bringing print time down to about 4.5 hours.
Being printed on Cocoon, in translucent purple ABS: photo 1 after first few layers, then at about 40% printed and lastly at end of print (still on the print bed).
More photos to come showing earrings attached. The height only allows for very short earrings.
Given reviews by chief usability tester, there are a couple of cycles of improvement: see 'earrings holder 2' (https://www.myminifactory.com/object/43954) and 'earrings holder 3' (https://www.myminifactory.com/object/44723).
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
Overhangs need support. See images for 100%- and 60%-sized prints, set up using Cura.
| Date published | 30/08/2017 |
| Cantidad de filamento | 51g |
| Dimensiones | 97.5 x 97.8 x 44.6 mm |
| Tecnología | FDM |
| Complejidad | Medio |
