Electronics Tweezers
Electronics Tweezers
Published 2020-08-21T05:55:23+00:00
Decided to build off my other tweezers design and made a pair for PCB work with tiny electronic components. Works well for the tiniest of screws, and I can hold wires safely while soldering.
Works well in a pinch if you're down a set of standard ESD protected tweezers. The tweezer tips are 1.25mm wide x 1.71mm tall, and are longer and thinner to grasp and manipulate small components on crowded PCBs.
Sanding Instructions:
If using an FDM/FFF printer, when printing small objects, fine tips often become slightly blobby. If this occurs for you, simply run the inside of the tips down with a fine grit sandpaper, only a pass or two should be needed.
Standard Print Settings:
Extruder: 208C
Bed: 56C
First Layer Print Height: .22mm
Wall Thickness: .40
Wall Perimeters: 4
Date published | 21/08/2020 |
Sin apoyo | YES |