Ender 3 E3D Hemera Mount
79,669
visitas
7,697
descargas
22
colecciones
110 comentarios
Cargando comentarios... 
Ender 3 E3D Hemera Mount
3D
Published 2019-11-25T18:46:06+00:00
444
110
Add to Collection
Descripción
Here's my first version of the E3D Hermes mount for the Ender 3. I might do some small teaks. Instead of the stock fan, I use a 40mm blower fan (same as the CR-10S Pro) as i feel it does a better job. It is secured to the fan with some super glue or hot glue. mount prints without supports, the blower duct might need just a little support on the curve from the build plate only.
This should also be compatible with Creality CR-10, CR-10S, CR-10 4S, CR-10 5S, CR20, Ender 5
Información técnica
| Date published | 25/11/2019 |
Más información
Archivos
These are the sample part I printed to get ready for my Hemera. I used a scrap roll of PLA, once I think it is good I'll use Carbon Fiber PLA. The fans are the ones I purchased from e-bay, haven't tested yet will provide update when complete