Halloween Ornament
Halloween Ornament
Published 2017-10-16T09:25:13+00:00
This is my halloween ornament I designed for the TinkerCAD competition. It's nothing special and you'll have to excuse the dodgy paintwork but it prints quite well. I had to rush mine so I lost some of the detail and i was silly with removing supports, but at a higher resolution and perhaps scaled up you could get some amazing finishes on this. Painting took me a few hours to do roughly!
This object was made in Tinkercad. https://www.tinkercad.com/things/4kaYrPwY0Qg
I printed it at 0.2mm layer height but that wasn't enough to capture the detail at it's current size. I'd recommend 0.15mm and scaling it up if you can, but its perfectly usable as it is! I used a raft but probably doesn't need it (it was just the setting it was on).
Date published | 16/10/2017 |
Tecnología | FDM |
Complejidad | Fácil |