Hinged Engraveable Ring Box For Proposals & Gifts
$3.00 Hinged Engraveable Ring Box For Proposals & Gifts
3D
Published 2020-09-07T15:25:20+00:00
A simple ring box I designed a while back, with two hinges. You can line the ring cutout and the upper lid with some cushioning if you want to spruce it up; and the outside of the box has been left intentionally blank so you can opt to either customize it yourself, or laser engrave it after the fact. (Ignore the black 'grime' on the surface, that's just print bed adhesive from my test print).
Dimensions:
Ring box (closed): 9.9cm x 6.9cm x 1.9cm
Ring cutout: 2.8cm x 2.8cm x 0.9cm (+ 0.9cm above in hollow lid)
10% infill should be fine. Test print pictured was done in Translucent Red PLA @15% infill. Might want a lot of shells so that the hinges have some good structure to them. You'll need supports for the hinges; and be careful with them. You might have to work the hinges a bit in order to get the pins inserted and spinning freely
10% infill should be fine. Test print pictured was done in Translucent Red PLA @15% infill. Might want a lot of shells so that the hinges have some good structure to them. You'll need supports for the hinges; and be careful with them. You might have to work the hinges a bit in order to get the pins inserted and spinning freely
| Date published | 07/09/2020 |
| Precio | $3.00 |
| Dimensiones | 13.9cm x 10.5cm x 1.3cm |