Indoor Garden
Indoor Garden
Published 2018-12-03T19:12:35+00:00
Indoor Garden project that was created in order to grow Kuroda carrots.The bottom of the pod is designed to house water in the event that over-watering happens. The pods will have to be sanded down and painted/sealed in order to house the product.
These are pretty tall, so we printed them in our MakerBot Z18. They could probably be cut in half in Mesh Mixer and glued together.
Work files are in the .zip
Supplies:
-Seeds
-Grow Light
-Filament
-Moisture & PH Sensors
-Squeeze Bottle
-Lumber (how ever big you wan the table to be)
-Super Glue
-Water Jug
-Floor Mat
-Dirt (research the seeds specific needs)
-Plastic Spray Paint
-Plasti-dip
Post processing:
1) Sand pods down with 60 or 80 grit paper then move to 120 or 200 grit
2) Spray paint with plastic spray paint
3) Spray plasti-dip
We printed ours at 0.3mm with a raft, but any resolution should be fine.
Date published | 03/12/2018 |
Sin apoyo | YES |