Invader Zim Irken Invader Pin / Badge
4,601
visitas
184
descargas
5
colecciones
0 comentarios
Cargando comentarios...
Invader Zim Irken Invader Pin / Badge
3D
Published 2017-05-04T14:46:36+00:00
36
0
Add to Collection
Descripción
Irken Invader Logo from the cartoon Invader Zim turned into a badge.
Print out 1 of each part. You will need some small brass nails and some lapel pin holders. You will also need some super glue, epoxy, or plastic weld to joing the parts together. I tried to provide pictures of how it assembles. It is pretty simple to assemble. I had mine done in about 15 minutes. As a note, the nails I had to cut down so the pin holders would fit.
Detalles de impresión
I Printed mine at .2mm layer height with 3 perimeters. And enough top and bottoms to make it solid. As the part is very thin and I figure it would take a lot of abuse.
Información técnica
Date published | 04/05/2017 |
¿Cuándo tiempo lleva? | - 60 minutos |
Dimensiones | 4.5in x 2.5in |
Tecnología | FDM |
Complejidad | Medio |
Sin apoyo | YES |
Más información
Archivos