iPhone Charge Stand
iPhone Charge Stand
Published 2018-10-01T03:42:13+00:00
This is the iPhone (lighting cable) version of what will eventually be a modular phone charging stand. The two small pieces are a cable adapter assemble sized to fit around an official lightning cable from Apple which then fit snugly in the top channel on the base. The charging cable can be routed out in 1 of 4 directions and the base plate is used to hide other exits. Having multiple pieces also gives you the option for different color schemes.
There are two types of charge adaptors. The open version exposes a bit more of the charging tip by having it flush to a little above the surface of the charge adaptors. Should allow it to work with thinner cases. The other version just has the flat tab sticking up and there is a thin wall of plastic housing the rest of the charge tip for a more finished lood.
If you want to have one made for you just head over and check it out on etsy.
No supports needed. Make sure to orient the charge adaptors on the flat back side. The criss crossing channels should be on the build plate, the channels have arches and do not require supports to print.
The charge adaptor pieces are probably the most annoying. You may need to play around with the scaling on the z axis to get the right fit. Basically... put the flat side on the bed, then lower or raise by .25mm to tight/loosen the fit. The cable in it adds a bit, so it should be on the loose side when you put the two pieces in by themselves.
Date published | 01/10/2018 |
¿Cuándo tiempo lleva? | 210 - minutos |
Cantidad de filamento | 150 |
Sin apoyo | YES |