Magnetic key holder
Magnetic key holder
3D
Published 2015-07-07T11:29:11+00:00
This is a magnetic key holder. You can get the magnets from ebay or DX.com. Size of the magnet is 4.8mm x 4.8mm and the hole that it fits in is 5mm x 5mm.
Pause your print at layer 238 (0.2mm layer height) or use your favorite slicer to find the right layer to stop at.
You can get the magnets from ebay or DX.com. Size of the magnet is 4.8mm x 4.8mm and the hole that it fits in is 5mm x 5mm. Pause your print at layer 238 (0.2mm layer height) or use your favorite slicer to find the right layer to stop at. You need to pause the print using the M0 (GCODE) command before the hole where the magnet should be place is closed. Also make sure you have a second magnet which you stick to the outside. This is to make sure that the magnet does not try and attach itself to the hotend.
| Date published | 07/07/2015 |
| ¿Cuándo tiempo lleva? | 60 - 70 minutos |
| Complejidad | Muy fácil |
| Sin apoyo | YES |
