Magnetic Knife Holder
Magnetic Knife Holder
3D
Published 2021-01-06T15:02:32+00:00
ATTENTION: I'm not responsible for damages or injuries caused if you decide to print and use this knife holder. There is always a change of it falling from the wall or other kind of trouble.
------------------------------------------------------
I made this simple magnetic knife holder. I was looking for something easy and fast to print, I also like it small, so it's hidden by the knife blade.
You just need a little bit of support on the slot made to fit the hanging strip. Depending on your printer capabilities, you might be able to print it with no supports at all.
You need 2 12mm x 2mm magnets and 1 large Command hanging strips.
Measure the hanging strip on the slot intended for it, then cut it. You need to cut it in half, approximately.
Use some of your favorite and strongest glue to fixate the magnets and the hanging strip. Let the glue cure for the recommended time, don't rush it.
Following the Command instructions, put the other half on the wall and wait the recommended time until it's safe to use.
=====
If you'd like to support me you can post a make, comment and/or pay me a coffee at PayPal
| Date published | 06/01/2021 |
| ¿Cuándo tiempo lleva? | - 40 minutos |
