Marbelvator, Armed (but not dangerous!), With Decisions
Marbelvator, Armed (but not dangerous!), With Decisions
3D
Published 2017-03-28T11:15:48+00:00
Again nothing to see here, just a different track. Yet, if you don't like my tracks, stay tuned...
Video of prototype of this track is here: https://www.youtube.com/watch?v=eoyVibiWV2o&feature=youtu.be.
This track runs best with 2 "marbles" using the recommended power supply set at 4.5 vdc with the recommended motor in the instructiona. As can be seen at this print speed, a little sanding and filing is required to clean it up if you print yours at this speed.
Designed using Sketchup Make 2015, and printed in PLA on a Makerbot Replicator 2 using Makerware 2.3.3.42 "Standard" Settings (.2mm layer height, 2 shells, 10% infill) at 200% print speed (only because it was late and I was tired).
See my other marbelvator for beginning instructions.
Insert "Y Pin.stl: into "Y Gate.st", making sure that the gate pivots freely on the pin. Then insert the assembly into "Track 4.st" such that "Y Gate.stl" swings freely.
Print all parts according to the instructions there, then print just this track and the associated pieces.
| Date published | 28/03/2017 |
| Tecnología | FDM |