Mavic Pro Propellor Case
1,726
visitas
98
descargas
0 comentarios
Cargando comentarios... 
Mavic Pro Propellor Case
3D
Published 2020-03-24T06:00:11+00:00
5
0
Add to Collection
Descripción
Designed and modeled a case for my Mavic Pro propellors. I often travel with the propellors off the drone so they don't get damaged and was looking for a solution to carry them separately. These only carry 4 at a time but they are seated in the case so they are not damaged rattling against the case or each other. The fit is relatively tight, my printer is tuned so they fit snugly but your experience may vary. If you've got any comments or suggestions please put them below!
Licencia
Detalles de impresión
0.2mm Layer Height. 15% Infill.
Case can be printed without support.
Lid must be printed with support, ~10% support density
Información técnica
| Date published | 24/03/2020 |
Más información
Archivos