Mockup Filament Spool Holder w/Bearings
Mockup Filament Spool Holder w/Bearings
3D
Published 2020-05-01T19:54:14+00:00
This is a mockup of the original spool holder that comes with the Ender 3 and Ender 3 Pro which uses the nut to fasten it onto the filament holder frame, it is designed for use with filament spools of different sizes including the small ones which don't have a smooth ID up to approx 2.7". Two 608srs bearings are needed for this print and the original filament spool holder nut is also needed, that file is not icluded, I have not designed it yet. If you do not use Ultimaker Cura for a slicer and don't put a support blocker in, I recommend using an exacto knife to cut away the support from the opposite side of the axle. It is quite difficult to pull the support apart although the final result is amazing.
I recommend .12 layer height and printing it vertical. Included is a .3mf Ultimaker Cura file with the settings that I used to print this perfect which also includes a support blocker that is used to create a seam which you can pry the support away much easier than otherwise.
| Date published | 01/05/2020 |
| ¿Cuándo tiempo lleva? | 660 - minutos |
| Cantidad de filamento | 49g |