Nine-Tailed Demon Fox
Sin soporte
Destacado
58,803
visitas
17,206
descargas
38
colecciones
Añadir a colección
931
79
79 comentarios
Cargando comentarios... 
Nine-Tailed Demon Fox
Published 2019-02-11T16:13:53+00:00
Descripción
There's something about nine-tailed fox spirits that fascinates me, this one is one of my favorites featured in the manga/anime Naruto.
This is a support free print by design, you can print the fox and the base separate or together.
My print was done using filament that changes color based on temperature (Amolen tri-color volcanic) and the effect is amazing but needs some heat source to bring it out, I used a hair dryer for the pics. No post processing otherwise.
Update: Due to feedback I've uploaded a version with sturdier tail root and slightly adjusted overhang that should be a bit easier to print. Please ensure your part cooling is up to the task too, if you don't think it can do the overhangs you do need to use supports.
Update 2: Added even easier version without the base with the fingers also fixed for better first layer adhesion.
Detalles de impresión
If you print without the base you probably need to use a brim to keep the first layer on the print bed, especially if you scale this down.
To print the tails without supports you do need a good part cooling, I used Z-hop and "avoid crossing perimeters" settings too to avoid crashing into any lifted overhangs.
Información técnica
| Date published | 11/02/2019 |
| Tecnología | FDM |
| Complejidad | Fácil |
| Sin apoyo | YES |
Archivos
Matterhackers Orange Pro PLA .2mm layer height, still came out with so much detail!