Nipple vise - clamp your darling!
Nipple vise - clamp your darling!
3D
Published 2019-10-04T10:15:11+00:00
I would like to share with you this amazing design for all of you interested in the special connection between pain and pleasure. This is a nipple vise for your self, your darling or your playmate. Just open it up, slip whatever body part you see fit in the opening and slowly tighten the screw to see your subject start wincing in pain as the spikes presses deeper and deeper into their flesh.
For extra painsure (pain/pleasure), hang some small weights from the handle to increase the fun.
Main body and moving part:
Has both internal and external threads, the body should be printed laying down as in the image, with the moving spikes placed inside the body so that it can be printed in place. The opening for the screw on the moving part should face the threaded opening of the body (of course).
Infill: 15-50%, anything will work more or less. No need to print 100% infill here, the forces will most likely not be that great.
Layer height: 0.2 - there are some clearances of 0.5 mm, so make sure your printer is dialed in before trying.
Supports: Can be printed without supports, but the rounded ends of the moving part will be deformed. I use Prusa Slic3r and just add supports to the very ends of that part so only the bottom of the rounded section gets support. No other support is needed.
Handle:
The handle should be printed standing up, with the threaded rod going upwards
Infill: 100%
Layer height: 0.2
Supports: No support is needed
| Date published | 04/10/2019 |
| ¿Cuándo tiempo lleva? | 180 - minutos |