PIR sensor faceplate - Bracket for PIR sensor with wire control.
5,670
visitas
303
descargas
3
colecciones
0 comentarios
Cargando comentarios...
PIR sensor faceplate - Bracket for PIR sensor with wire control.
3D
Published 2018-02-16T15:04:56+00:00
53
0
Add to Collection
Descripción
I recently started using PIR sensors with my raspberry pi to automate some lights at home! I searched for some PIR brackets but couldn't find any that were usable for my case.
These brackets are simple, no fitting required for the sensor unless you specifically wish to secure the sensor. For me, the push fitment was enough to keep my sensor stationary.
One bracket is a right andle and one is slightly angled to allow for pointing down if mounted high in a room.
There a 5mm cable guide at the back of the bracket for extra tidiness!
Detalles de impresión
Printed at .2 layer height with 40% infill. They take about 1 hour to print with no need for supports if printed on their side.
Información técnica
Date published | 16/02/2018 |
¿Cuándo tiempo lleva? | - 60 minutos |
Cantidad de filamento | 10 grams |
Dimensiones | 50x48x38 |
Tecnología | FDM |
Complejidad | Fácil |
Sin apoyo | YES |
Más información
Archivos