Ports/Harbours for the Boardgame "Merchants & Marauders" or in german "Korsaren der Karibik"
6,542
visitas
383
descargas
8
colecciones
1 comentarios
Cargando comentarios... 
Ports/Harbours for the Boardgame "Merchants & Marauders" or in german "Korsaren der Karibik"
3D
Published 2017-10-03T11:10:39+00:00
11
1
Add to Collection
Descripción
These ports are for the boardgame "Merchants & Marauders" and they fit on the spaces on the gameboard, so the board won´t get crowded when you use these ports. The towers have a hole to fit the flags from the expansion inside.
Detalles de impresión
Printed with ABS and a layer height of 0,2mm
Información técnica
| Date published | 03/10/2017 |
| Tecnología | FDM |
| Complejidad | Muy fácil |
| Sin apoyo | YES |
Más información
Archivos
Here are (plenty of!) images of my print. I hadn't realised that the towers should have four sides until after printing all the English ports - but the two thin walls on the models didn't print. My solution was to put a few turns of cling film around the base of each flag pole so it's nice and snug. Without the thin walls, there were four model i had to edit to get an intact tower (Trinidad, San Juan, Havana and Curacao). I used 0.16mm layer height and 20% in-fill